Engine Build Sheet Template - It is a restoration project for sure, but it runs and drives and has a pontiac 350 in it. When i tore into the engine, i could still see the cross hatching on the cylinders so i took it to the machine shop to be cleaned up and installed new bearings, rings and gaskets. I kept some parts for use on the new car and the spreadsheet came with it. I had all the bits and looked at everything else. The mh build worksheet started out with my previous car which i parted out. The build had less than 1000 miles on it from what i can tell before the previous owner wrapped the rear end around a pole. Picked up from craigslist for 1350.00 after some negotiation. A close examination of shaver's engine reveals the details. Anyway, i want to swap a pontiac 400 in it someday and want to know a good budget build to get around 400lb/ft of torque. Rods, and brand, any length as long as pistons avalible for size. Engine is rebuilt, unknown milage but very few (under 10,000) from the information i gathered. I had the engine build sheet but lost it. Overbore max.060 crank, any brand, off the shelf. Must be off the shelf no custom built. I have each area of the car broken up into sections, hyperlink where i can and the number of every scanned receipt.
Overbore Max.060 Crank, Any Brand, Off The Shelf.
The engine currently is a very weak 305 with a th350 transmission. Thick ss material and a ss screw on cap with o'ring. 6.0 l96, t56, strange 9 inch, ridetech coilovers, wilwood brakes It is a restoration project for sure, but it runs and drives and has a pontiac 350 in it.
He Said That It Wouldn't Be A Problem.
I was looking at sheck44's '69 camaro build and he had a remote power steering reservoir that was made by a guy in california. Engine is rebuilt, unknown milage but very few (under 10,000) from the information i gathered. I had all the bits and looked at everything else. I had the engine build sheet but lost it.
When I Tore Into The Engine, I Could Still See The Cross Hatching On The Cylinders So I Took It To The Machine Shop To Be Cleaned Up And Installed New Bearings, Rings And Gaskets.
A close examination of shaver's engine reveals the details. I kept some parts for use on the new car and the spreadsheet came with it. I contacted him and asked him if he would build me a overflow to my dimensions and the way i wanted it built. Picked up from craigslist for 1350.00 after some negotiation.
It Also Came With A Dyno Sheet.
The mh build worksheet started out with my previous car which i parted out. I have each area of the car broken up into sections, hyperlink where i can and the number of every scanned receipt. Build a natuarlly aspirated small block chevy, that will produce 600hp at the flywheel. I do however have a link to the engine running before it was removed and sold to me.